Skip to content
STABLEρ

Bulk density

CylinderResult in g/cm³IS 2720 (Part 29)IS 16556

Weighed in a measuring cylinder

Formula
BD =(W2−W1)V

Your readings

3 of 3 filled

Example values shown.

g
g
ml
Bulk densityCalculated live as you type
1.315 g/cm³g/cm³
Within the usual range. Most mineral soils: 1.1–1.6 g/cm³.

Calculations you finish this week are counted here, on this device only.

How bulk density is calculated

Free bulk density calculator (cylinder method), following IS 2720 (Part 29), IS 16556. Enter 3 readings to get bulk density in g/cm³, with the formula filled in step by step.

  1. Bulk density · g/cm³

    BD = (W2 − W1) / V

What you need

SymbolReadingUnitNotes
W1Weight of the dry 100 ml cylindergusually 10–500 g
W2Weight of the cylinder with samplegusually 10–1000 g
VVolume of the sample after compactionmlusually 10–100 ml

Worked example

Readings:

  • Weight of the dry 100 ml cylinder: W1 = 92.4 g
  • Weight of the cylinder with sample: W2 = 218.6 g
  • Volume of the sample after compaction: V = 96 ml
  1. Bulk density

    BD = (218.6 − 92.4) / 96 = 1.315 g/cm³

Result: Bulk density 1.315 g/cm³.

Checks and units

  • Typical values: Most mineral soils: 1.1–1.6 g/cm³
  • The cylinder with sample (W2) must weigh more than the empty cylinder (W1).

Questions

How do you calculate bulk density by the cylinder method?

Bulk density = (W2 − W1) / V. Here W1 is the weight of the dry 100 ml cylinder (g), W2 is the weight of the cylinder with sample (g), V is the volume of the sample after compaction (ml). The result is in g/cm³.

What unit is bulk density reported in?

Bulk density is reported in g/cm³, to 3 decimal places.

Which standard does this bulk density calculation follow?

It follows the calculation in IS 2720 (Part 29), IS 16556. Check it against the current edition of the standard and your lab’s SOP before reporting.

Can you show a worked example?

With weight of the dry 100 ml cylinder = 92.4 g, weight of the cylinder with sample = 218.6 g, volume of the sample after compaction = 96 ml, the result is bulk density = 1.315 g/cm³.

What is a typical bulk density value?

Most mineral soils: 1.1–1.6 g/cm³

What mistakes should I look out for?

The cylinder with sample (W2) must weigh more than the empty cylinder (W1).

Is this bulk density calculator free?

Yes. It’s free with no sign-up. The calculation runs in your browser and nothing you type is sent to NovaLIMS.

Check results against your own method and SOP before reporting. Found an error? Tell us and we’ll check it.

Run every calculation inside your LIMS

NovaLIMS puts these calculators right beside each sample’s parameters, for every analyst in the lab.