Skip to content
STABLETSS

Total suspended solids

GravimetricResult in mg/LIS 3025 (Part 17)

Residue on a filter, weighed

The filter is weighed with the dish before and after, so its own weight cancels out.

Formula
TSS =(A−B)×1000000V

Your readings

3 of 3 filled

Example values shown.

ml
g
g
Total suspended solidsCalculated live as you type
62.0 mg/L
Within the usual range. Treated effluent: usually below 100 mg/L.

Calculations you finish this week are counted here, on this device only.

How total suspended solids is calculated

Free total suspended solids calculator (gravimetric method), following IS 3025 (Part 17). Enter 3 readings to get total suspended solids in mg/L, with the formula filled in step by step.

  1. Total suspended solids · mg/L

    TSS = (A − B) × 1000000 / V

What you need

SymbolReadingUnitNotes
VVolume of sample takenmlusually 1–1000 ml
BWeight of dish with filter, beforegusually 0–200 g
AWeight of dish with filter and residue, after dryinggusually 0–200 g

Worked example

Readings:

  • Volume of sample taken: V = 100 ml
  • Weight of dish with filter, before: B = 32.125 g
  • Weight of dish with filter and residue, after drying: A = 32.1312 g
  1. Total suspended solids

    TSS = (32.1312 − 32.125) × 1000000 / 100 = 62.0 mg/L

Result: Total suspended solids 62.0 mg/L.

Checks and units

  • Typical values: Treated effluent: usually below 100 mg/L
  • The weight after drying (A) is less than before (B). Check the weighings.
  • Other units: ppm (1 mg/L ≈ 1 ppm in dilute water).

Questions

How do you calculate total suspended solids by the gravimetric method?

Total suspended solids = (A − B) × 1000000 / V. Here V is the volume of sample taken (ml), B is the weight of dish with filter, before (g), A is the weight of dish with filter and residue, after drying (g). The result is in mg/L.

What unit is total suspended solids reported in?

Total suspended solids is reported in mg/L, to 1 decimal place. The calculator can also show it in ppm (1 mg/L ≈ 1 ppm in dilute water).

Which standard does this total suspended solids calculation follow?

It follows the calculation in IS 3025 (Part 17). Check it against the current edition of the standard and your lab’s SOP before reporting.

Can you show a worked example?

With volume of sample taken = 100 ml, weight of dish with filter, before = 32.125 g, weight of dish with filter and residue, after drying = 32.1312 g, the result is total suspended solids = 62.0 mg/L.

What is a typical total suspended solids value?

Treated effluent: usually below 100 mg/L

What mistakes should I look out for?

The weight after drying (A) is less than before (B). Check the weighings.

Is this total suspended solids calculator free?

Yes. It’s free with no sign-up. The calculation runs in your browser and nothing you type is sent to NovaLIMS.

Related calculators

All water & waste water calculators →

Check results against your own method and SOP before reporting. Found an error? Tell us and we’ll check it.

Run every calculation inside your LIMS

NovaLIMS puts these calculators right beside each sample’s parameters, for every analyst in the lab.