Skip to content
STABLEOG

Oil and grease

Partition-gravimetricResult in mg/LIS 3025 (Part 39)

Weighed residue on a balance

Formula
OG =(W2−W1)×1000000V

Your readings

3 of 3 filled

Example values shown.

ml
g
g
Oil and greaseCalculated live as you type
7.2 mg/L
Within the usual range. Discharge to inland surface water: up to 10 mg/L.

Calculations you finish this week are counted here, on this device only.

How oil and grease is calculated

Free oil and grease calculator (Partition-gravimetric method), following IS 3025 (Part 39). Enter 3 readings to get oil and grease in mg/L, with the formula filled in step by step.

  1. Oil and grease · mg/L

    OG = (W2 − W1) × 1000000 / V

What you need

SymbolReadingUnitNotes
VVolume of sample takenmlusually 1–1000 ml
W1Weight of empty dish (W1)gusually 0–200 g
W2Weight of dish with residue (W2)gusually 0–200 g

Worked example

Readings:

  • Volume of sample taken: V = 1000 ml
  • Weight of empty dish (W1): W1 = 62.441 g
  • Weight of dish with residue (W2): W2 = 62.4482 g
  1. Oil and grease

    OG = (62.4482 − 62.441) × 1000000 / 1000 = 7.2 mg/L

Result: Oil and grease 7.2 mg/L.

Checks and units

  • Typical values: Discharge to inland surface water: up to 10 mg/L
  • The weight after (W2) is less than before (W1). Check the weighings.
  • Other units: ppm (1 mg/L ≈ 1 ppm in dilute water).

Questions

How do you calculate oil and grease by the Partition-gravimetric method?

Oil and grease = (W2 − W1) × 1000000 / V. Here V is the volume of sample taken (ml), W1 is the weight of empty dish (W1) (g), W2 is the weight of dish with residue (W2) (g). The result is in mg/L.

What unit is oil and grease reported in?

Oil and grease is reported in mg/L, to 1 decimal place. The calculator can also show it in ppm (1 mg/L ≈ 1 ppm in dilute water).

Which standard does this oil and grease calculation follow?

It follows the calculation in IS 3025 (Part 39). Check it against the current edition of the standard and your lab’s SOP before reporting.

Can you show a worked example?

With volume of sample taken = 1000 ml, weight of empty dish (W1) = 62.441 g, weight of dish with residue (W2) = 62.4482 g, the result is oil and grease = 7.2 mg/L.

What is a typical oil and grease value?

Discharge to inland surface water: up to 10 mg/L

What mistakes should I look out for?

The weight after (W2) is less than before (W1). Check the weighings.

Is this oil and grease calculator free?

Yes. It’s free with no sign-up. The calculation runs in your browser and nothing you type is sent to NovaLIMS.

Related calculators

All water & waste water calculators →

Check results against your own method and SOP before reporting. Found an error? Tell us and we’ll check it.

Run every calculation inside your LIMS

NovaLIMS puts these calculators right beside each sample’s parameters, for every analyst in the lab.